EFTA02443836.pdf

To: Je vacation '[email protected]] From: Sent: Thur 6/18/2009 2:32:36 PM Subject: Re: I understand, Carlos suggested just to use carbon fiber as front panel to locate new gauge clusters„I thought is was easy to drill into and would be water resistant. Do you think stained or painted ply wood is acceptable as face plate for panel? Or other material choices? -note: the dealer in St. Thomas has our 30K deposit for Suzuki engines, should we recover money or just stand by? Thank you, Larry Original Message From: Je vacation To: Larry Sent: Jun 18, 2009 10:13 AM Subject: Re: overkill and hard to work On Thu, Jun 18, 2009 at 10:10 AM, <[email protected] <mailto:[email protected]> > wrote: That should be a sample to use as a dash board for Nana console, there are more holes in panel than needed. That is what Harris used on old midnight expressed panel to cover old hole. I have not seen sample yet. Original Message From: Je vacation To: Larry Sent: Jun 18, 2009 10:06 AM Subject: why did i get the carbon fibre from carlos? Sent from my BlackBerry® wireless handheld Sent from my BlackBerry® wireless handheld EFTA_R1_01519354 EFTA02443836