EFTA01140269.pdf

From: Larry Visoski To: Je vacation <jeevacation®gmail.com> Subject: Fwd: G-IV Date: Mon, 23 Dec 2013 13:18:27 +0000 Inline-Images: IMG_8182.jpg; IMG_2504.jpg; IMG_7443.jpg; IMG_5057.jpg; IMG_5673.jpg; IMG_0815.jpg; IMG_3119.jpg Photos of wing painting, Jeffrey Update from paint shop this morning, GIV should be done Dec 24th late afternoon, they had delays. The earlier messages projected the plane for dec27 th Sent from my iPhone Begin forwarded message: From: Cory Moses > Date: December 23, 2013 at 8:21:05 AM AST To: ' Cc: T son Grenzebach , Blake Bowen Subject: GIV Good morning Larry, As of now wings are sanded, NC is being masked and we are preparing to start painting wings. Worse case senario is we will be pulling trigger at 10AM hopefully sooner. The base takes 2 hours to dry before I can clear, the dry time per tech data sheet is 16 hours for clear.What time were you wanting to pick up your NC on 24th of December? If you could work it into your schedule to pick it up later in afternoon that would be great. We are doing everything we can to try to get you your NC asap. I wanna thank you for your patience and support through this situation. Please advise with your plans. Regards, Cory Moses Assodated Painters Inc Paint Operations Supervisor Sent from my iPhone Begin forwarded message: From: Cory Moses Date: December 22 2013 at 8:26:55 PM AST To: " " EFTA01140269 Cc: T son Grenzebach , Blake Bowen Subject: G-IV Good evening Lany , We are a little behind schedule, we are taking every precaution possible to ensure there is no more issues with wings or any further paint failures. Per tech data sheets the high build primer requires at least 12 hour dry time before sanding. I made the decision to let the primer sit for 24 hours before sanding to ensure it was dry and guarantee proper adhesion. As you can see from the pies I sent the left wing is completely sanded and the right wing is about half sanded. To be 100% honest and not beat around the bush with you, with this week being Christmas I don't see your A/C being complete until Friday. We will finish sanding tomorrow and take mil readings and average paint thickness to be sure to stay with in our limitations. We will then un mask A/C entirely and wash re mask and paint wings tomorrow or 1st thing Christmas Eve morning I am personally going to paint it. I apologize if this puts a damper on your plans more then this entire situation already has. Possibly could be sooner then Friday. Please advise with your plans Regards, Cory Moses Associated Painters Inc Paint Operations Supervisor Sent from my iPhone EFTA01140270 EFTA01140271  . . EFTA01140272 EFTA01140273 EFTA01140274 EFTA01140275 EFTA01140276 EFTA01140277